Edward Pais was a classmate of mine at Deerfield Academy from 1986 to 1990, and he now practices architecture in Burlington, Vermont. Despite being out of touch for more than two decades we recently reconnected via Facebook. Ed joined the Rosslyn Redux Facebook page and he’s offered ongoing feedback about our boathouse during the Lake Champlain flooding. Recently he offered to come over and take a look. Needless to say, I eagerly accepted his offer.
We started out with a delicious lunch at Essex Provisions overlooking the still flooded marinas, then headed back to Rosslyn to take a look at the boathouse.
Ed’s reaction was encouraging, and despite pushing him into engineering territory a couple of times, I mostly listened and took mental notes. He reminded me that he’s an architect and not an engineer, but repeatedly expressed his confidence in the work of Engineering Ventures in Burlington. Paul Hobbs who handled most of the structural engineering for the boathouse renovation repeatedly impressed with his keen mind, so Ed’s confidence was not misplaced. That said, I do intend to follow up with Hobbs and/or Jeffords Steel to ascertain whether or not the beams which support the suspended pier were fabricated out of COR-TEN or a similar weather resistant steel.
Ed’s recommendation to quickly and aggressively treat the mold situation was highlighted in a follow-up message after his visit. He suggested that we should remove the baseboards to inspect for mold. He linked me to helpful information “Cleaning Mold on Wood” that confirms that we’ve been remediating the post-flood mold situation appropriately.
The molds seen on lumber are largely a collection of fungal spores on the surface of the wood. Wet wiping and scrubbing the lumber will remove the mold. But simply wiping the wood can release spores into the surrounding air. A better approach is to gently spray or wet down the mold prior to removal.
There are a number of products on the market, ranging from common bleach to commercial mildewcides, which are promoted for cleaning mold from wood. However, the U.S. Environmental Protection Agency suggests using a mild detergent and water for most mold clean up. The EPA recommends wet vacuuming the area, wiping or scrubbing the mold with detergent and water and, after drying, vacuuming with a high-efficiency particulate air (HEPA) vacuum.
Common bleach and water can be used for cleaning mold. The U.S. Centers for Disease Control (CDC) recommends using a solution of 10 parts water to one part bleach to clean mold from surfaces. (Western Wood Products Association)
Huge thanks, Ed, for taking the time to coach me through the latest challenge! I really appreciate it.
After De’s departure my parents joined us for dinner. They’ve just returned to the Adirondacks from Chicago for the summer, so grilling and dining al fresco seemed like the perfect way to launch their summer. While showing my mother the recovering boathouse, I asked if she remembered Ed Pais from Deerfield. She did! She recounted a story that I’d never known. My brother, two years younger than I, had come to Deerfield for his admissions interview. Although he already knew his way around because he had visited me frequently, he decided to take the admissions office campus tour anyway. His tour guide was Ed Pais! When we got back to the house I asked my father if he remembered Ed Pais, and he immediately told me the same story! Ed, must have made quite an impression…
Leave a Reply